1. Which DHCPv4 message will a client send to accept an IPv4 address that is offered by a DHCP server? unicast DHCPACK broadcast DHCPACK unicast DHCPREQUEST broadcast DHCPREQUEST*    2. A company uses DHCP servers to dynamically assign IPv4 addresses to employee workstations. The address lease duration is …

CCNA Security v2.0 Final Exam Answers 1. Refer to the exhibit. Based on the security levels of the interfaces on ASA1, what traffic will be allowed on the interfaces? Traffic from the Internet and LAN can access the DMZ. Traffic from the Internet and DMZ can access the …

CCNA 2 v5.03 Final Exam Answers 2017 1. Which type of traffic is designed for a native VLAN? management user-generated un tagged tagged* 2. Which two statements are correct if a configured NTP master on a network cannot reach any clock with a lower stratum number? The NTP …

1. In which configuration would an outbound ACL placement be preferred over an inbound ACL placement? when the ACL is applied to an outbound interface to filter packets coming from multiple inbound interfaces before the packets exit the interface* when a router has more than one ACL when …

1. What are three primary benefits of using VLANs? (Choose three.) security* a reduction in the number of trunk links cost reduction* end user satisfaction improved IT staff efficiency* no required configuration   2. Which type of VLAN is used to designate which traffic is untagged when crossing …

1. Which statement describes the port speed LED on the Cisco Catalyst 2960 switch? If the LED is green, the port is operating at 100 Mb/s.* If the LED is off, the port is not operating. If the LED is blinking green, the port is operating at 10 …

1. A network designer must provide a rationale to a customer for a design which will move an enterprise from a flat network topology to a hierarchical network topology. Which two features of the hierarchical design make it the better choice? (Choose two.) lower bandwidth requirements reduced cost …

1. Which dynamic routing protocol was developed to interconnect different Internet service providers? BGP* EIGRP OSPF RIP   2. Which routing protocol is limited to smaller network implementations because it does not accommodate growth for larger networks? OSPF RIP* EIGRP IS-IS   3. What two tasks do dynamic …

1. What are two advantages of static routing over dynamic routing? (Choose two.) Static routing is more secure because it does not advertise over the network.* Static routing scales well with expanding networks. Static routing requires very little knowledge of the network for correct implementation. Static routing uses …

1. A network administrator enters the command copy running-config startup-config. Which type of memory will the startup configuration be placed into? flash RAM NVRAM* ROM   2. Which packet-forwarding method does a router use to make switching decisions when it is using a forwarding information base and an …